11/19/2023 0 Comments Patina cars and trucks for sale![]() ![]() Our Chassis Armor is a high performance coating designed for application directly on rust or seasoned metal surfaces It can be either brushed, rolled, or sprayed. Poppy’s Chassis Armor is a single pack moisture cure urethane that is designed to prevent or stop rust. *Lay used rags and applicators out flat to dry properly before disposing of, to avoid any spontaneous combustion. *This product may also be sprayed using a HVLP Spray Gun with a 1.4 nozzle at 35 psi* *We recommend using spray-on application if applying over cheaply applied paints, this includes spray can, alkyd coatings and 1k applications - remember to always test on a small area first. *Poppy’s Clear Coats may cause chemical rewetting or wrinkling of (some) finishes.* Use acetone or xylene to remove from unwanted surfaces. If you have missed a spot or have an imperfection to correct, allow 24 hours to cure before scuffing that area and re-applying.Īllow 20-30 minutes for dry to touch and 24 hours for full cure. Once product has been applied do not wipe over the same area again. Mixed product will have a two hour pot life at 77 (25☌) degrees.īlow off provided Applicator Pad before use to get rid of loose fibers.Īfter surface is completely dry, with our Wipe-On Clear Coat wet a provided Applicator Pad in a paint tray for large areas.įor small hard to get to areas, wet one of our Recycled Knit Rags and wipe on.Īlways apply to a small inconspicuous area to test results before going over entire vehicle.Īpply thinly and quickly to one panel at a time. Our Clear Catalyst can be mixed at a ratio of 8:1 to achieve chemical resistance. Then with our Wax & Grease Remover use 2 Rags - wet one rag, then wipe on while drying with the other clean dry rag - before applying the clear coat. Rinse thoroughly and let dry -completely. Wash the surface thoroughly with our Pre-Cleaner and water using a Light Duty Grey Scuff Pad removing as much loose scale, dirt, grit, and oxidation as possible. How much do I need? One 32oz container will cover one long bed C10 Truck+Īlways wear appropriate personal protective equipment, and for best results use in a well ventilated area at a temperature between 50☏ (10☌) and 77☏ (25☌). If spraying allow 20 minutes of flash time between coats. If wiping wait 24 hours after first application and give the surface a light scuff then apply. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |